there is nothing to be bent in the rear of the car, in terms of the frame... unibody does not bend that easy, unless you were hit by a mack truck. went through the same nightmare scenario last winter... & in my case it was a bent trailing arm & a bent subframe cross member (both replaced). ebay is your friend. your camber will always be off, if the car is lowered.... __________________ SOLD!SOLD!SOLD!SOLD!SOLD!SOLD!SOLD!SOLD! Metric Mechanic's 2.0 stroker/258' intake cam/42 lb. inj./remap/HD fuel pump /DASC w.3' pulley @ 15psi/SNOW System/3.45 LSD/Billstein PSS coils /Stromung Exhaust/DS1's/X-Brace/Front & Rear H&R Sways/OMP 300mm SW /SAP delete/ASC+T delete/Hayabusa valve springs/MM's LTW flywheel Last edited by marko; 04-10-2010 at 06:28 PM. |