Quote:
Originally Posted by Crashaddict  thats one of the issues im trying to work out. i figure if i make it one solid piece, the wheel wells will hold it in place. ill be removing that fat sensor from the seatpan, and am considering using the screws from that to make it sit flush against the pan. for the sides im considering just making a solid skirt covered in carpet, that i can secure in place of the bolsters, ind like to use foam, but foam+glue does not exactly work too well |
I used supports riveted to the floor and square tubing behind the seats to support it and hold it in place and then machine screws and rivnuts to fasten it.
Also, it was over 4' wide behind the wheel wells and 5' long so it had to be 2 pieces.
This one is in a Mazda 323 work beater