View Single Post
Old 08-06-2016, 10:14 AM   #5
RACERetteX
Junior Member
 
Join Date: May 2015
Location: Herndon, Va
Posts: 21
iTrader: (0)
Default

Ok. I'll compile it all and write up a how-to.
Note: these were NOT a direct bolt-in, but so far as I know (did quite a bit of asking around with E36 nuts) any E36 seat will work. The luxury/comfort (read: base level) seats will be very like the stock Ti seats, as they have minimal bolstering. Also note, the swap doesn't seem to differ if the donor seats are manual or powered. Mine were power with heat (not wired in yet).

This build required full donor seats and swapping the bases from ours onto the new seats from the donor. It's not TOO difficult, but does require a little mechanical intuition and a solid afternoon.

Teaser pic for now...
Attached Thumbnails
Click image for larger version Name:	image.jpg Views:	350 Size:	43.3 KB ID:	16423  
RACERetteX is offline   Reply With Quote