318ti.org forum - View Single Post - Custom M44 Eaton Supercharger Build-- Long Overdue

TheDude · 01-13-2015, 07:34 PM

Now that the rail is in place i started the fabrication of the plate that the Supercharger will fit on. One of the hardest parts of this project was deciding on a belt tensioner design. I ended up using the tensioner from a Nissan Quest, because its all self contained and no bigger than 6 inches long for the whole assembly. So it was welded to the Supercharger Plate.

Click image for larger version Name: photo 2 (3).jpg Views: 343 Size: 43.6 KB ID: 15520

Click image for larger version Name: photo (4).jpg Views: 350 Size: 45.7 KB ID: 15521

Click image for larger version Name: IMG_1295.jpg Views: 394 Size: 60.5 KB ID: 15522

Click image for larger version Name: IMG_1294.jpg Views: 354 Size: 36.6 KB ID: 15523

Click image for larger version Name: IMG_1292.jpg Views: 329 Size: 34.5 KB ID: 15524

In between days i rebuilt the SuperCharger.

01-13-2015, 07:34 PM	#7
TheDude Member Join Date: Jan 2015 Location: Plano, TX Posts: 35 iTrader: (0) Photo Gallery	Now that the rail is in place i started the fabrication of the plate that the Supercharger will fit on. One of the hardest parts of this project was deciding on a belt tensioner design. I ended up using the tensioner from a Nissan Quest, because its all self contained and no bigger than 6 inches long for the whole assembly. So it was welded to the Supercharger Plate. In between days i rebuilt the SuperCharger.