Thread: rally car build
View Single Post
Old 03-20-2017, 09:33 PM   #5
jerseytim
Member
 
Join Date: Jun 2016
Location: jersey
Posts: 55
Vehicles
iTrader: (0)
Default


this is a box i made to raise the foot of the main hoop, if the foot was bolted directly to the floor i would have problems removing the rear half of the cage out of the car
trial fitting the main hoop
i bought a hole cutter for notching the tubes but found a good vid on youtube about notching the tubes with an angle grinder which works well, can't fit any more of the cage until i receive the front legs, can't fit the diff until i get the new diff mount, next job will be to weld in the seat rails, rail plates and harness eyes
jerseytim is offline   Reply With Quote