318ti.org forum - View Single Post

tlh2011 · 07-04-2015, 03:22 PM

I think buy a M3 gauge cluster for put in my 323ti, because have oil temp.
Some doubts:

-The rear conector cluster is the same?

-If I bought one cluster with odometer in miles I can change by kilometer correct?

- To make oil temp work, I need to connect a wire to pin #13 on the back of the cluster? (if I'm not wrong in the original cluster of m3 is in the #13, but in the 323ti?) - I need the sensor, pass wire in the sensor-> ?big black round connector?fuse box? -> cluster

-The speedometer will go indicate correct or the sensor or calibration is differente?

-I need also a cap filter oil with conection of oil sensor =)

Someone already make this?

07-04-2015, 03:22 PM	#1
tlh2011 Junior Member Join Date: May 2015 Location: Brazil Posts: 13 iTrader: (0) Photo Gallery	Gauge cluster M3 ( oil temp) 323ti I think buy a M3 gauge cluster for put in my 323ti, because have oil temp. Some doubts: -The rear conector cluster is the same? -If I bought one cluster with odometer in miles I can change by kilometer correct? - To make oil temp work, I need to connect a wire to pin #13 on the back of the cluster? (if I'm not wrong in the original cluster of m3 is in the #13, but in the 323ti?) - I need the sensor, pass wire in the sensor-> ?big black round connector?fuse box? -> cluster -The speedometer will go indicate correct or the sensor or calibration is differente? -I need also a cap filter oil with conection of oil sensor =) Someone already make this?