Ok, had some more time to look at the car. Battery is ~12.5V at rest so that is okay. I received my new coil (looks like it has been dropped in transit though) and the car would not start at first. It did start after a few attempts but stalled. Then it ran for a little while and I was able to check with INPA while it was running. No change to any of the readings and smoothness is way out on cylinder 2 and less so on cylinder 3. Then it died again and wouldn't start. INPA was reporting cam sensor fault code again (112) so I unplugged the sensor and it started next attempt. I turned it off and re-connected the cam sensor and it started fine again. Cam sensor fault code is appearing almost immediately now. As mentioned I had replaced it with a second hand one so maybe that one is faulty? Is there anything else that can cause this error code (unplausible value it says)? Timing chain slackness or mis-firing perhaps? I may have to try another cam sensor but I am getting sick of spending money on things that may not be needed. |