View Single Post
Old 04-11-2012, 04:44 PM   #2
Mic10is
Member
 
Join Date: Feb 2012
Location: YORK,PA
Posts: 74
iTrader: (0)
Default

cut the bracket in the back of the opening. there is a plastic bracket with a hole in the middle that the OEM head unit slid into. cut that and it will fit much better.
move wire harness to one side or the other. you have to feel around, i usually tuck it all on the left side between the dash and the vent. there is deadspace, not a ton but enough for wires to be crammed into to push the head unit in.

without cutting that bracket out, its a VERY tight fit and a major pain the ass
Mic10is is offline   Reply With Quote