318ti.org forum - View Single Post - CA ///BMW 318 & Z3 Dual Mass Flywheel & Clutch Kit

JP422 · 09-07-2010, 01:08 AM

Hi trusted-1, Did you install your upgraded clutch yourself?
If you don't mind, I have a few questions on your setup.

What parts did you use on your upgrade? Mine is a larger 240mm M3 size conversion, but strangely, something is hitting (I think flywheel bolts) when the clutch gets disengaged. The sprung hub (M5/6) I'm using is flipped backward into the machined hollow of the Fidanza M3 flywheel. The disk wont fit if it's not flipped, as it will hit the M3 pressure plate.

I'd appreciate it if you can share some tips.

Thanks.

-Joe.

09-07-2010, 01:08 AM	#4
JP422 Member Join Date: May 2010 Location: CA Posts: 95 iTrader: (0) Photo Gallery	Hi trusted-1, Did you install your upgraded clutch yourself? If you don't mind, I have a few questions on your setup. What parts did you use on your upgrade? Mine is a larger 240mm M3 size conversion, but strangely, something is hitting (I think flywheel bolts) when the clutch gets disengaged. The sprung hub (M5/6) I'm using is flipped backward into the machined hollow of the Fidanza M3 flywheel. The disk wont fit if it's not flipped, as it will hit the M3 pressure plate. I'd appreciate it if you can share some tips. Thanks. -Joe.