Quote:
Originally Posted by Diavel The one (only) good thing about Illinois is I don't have to worry about getting my Ti emissions tested due to it being 1995 or older. (OBDI) |
Not fair.... but honestly here in SoCal if 1995 cars and older didn't have to smog...
It would be nuts - all the civics/240s/datsuns/BMW's (basically any car with a enthusiast base) etc there are SOO many cars that people would just start bolting turbo's on or doing crazy swaps on.
Quote:
Originally Posted by Strawman One more thing: if you end up pulling your trans, think about replacing the detent pins -- there are write-ups on BF, and post #37 in http://www.318ti.org/forum/showthread.php?t=38844 shows the tools I spun up for the job. The new pins/covers kit is about $75 from Pelican. PM me if you wanna tackle this job and we'll figure out how to loan the tools. |
Hey Strawman!
I'm honestly trying to keep it simple. Not really wanting to pull the trans if I don't have to!
Quote:
Originally Posted by Strawman I used the ZF transmission, trans crossmember, shifter and driveshaft out of a wrecked 1997 328ic convertible, bolted up to a medium-case E28 differential. This all fit without modification and the shifter was centered in the console. I use E36 M3 motor mounts and stock rubber trans mounts; I originally used poly trans mounts, but it buzzed too much with my single-mass flywheel. I had to clearance the welded-in chassis brace to clear the differential (that could be your clunk) with a BFH, and I used poly bushings for the rear suspension crossmember to limit twist (and possible clunking, which happens slightly when in reverse). This was my setup with the M52, but when I swapped in the S52 I swapped in a Z3 shifter and it is still centered. |
That is some great info! I will look into it, but now at least it is confirmed for me that strait 328 ZF trans etc will work, now I just need to make sure no getrag parts made it in there by accident. Once its all set and I am happy I gotta come up and see how my m52 runs against your s52. It would be interesting, see if the m52 w/s52 head + 3.46diff would be comparable against your s52 + 2.93 diff - if you still are running that diff!