Had to work this afternoon, but had a good morning! Head looks really nice now, and had the tiniest amount skimmed from the block side. Looks really good! Taped it up and painted all the open bits. Taping was a mission, least favourite part (even more tedious than the valve springs.. Haha!)
Looks quite nice I think, and I'm far from a professional!!!!
Just like the rest I will wait a week for the paint to cure properly, sand it with a very fine grit, and give her a last coat for a nice even finish!
Attacked the valve cover (does anybody know where I can get the little rubber grommets for the bolt seals from? They were US$.50 on turner and pelican parts, but $44 for shipping!!!, if I can find a local supplier that would be awesome). Degreased the inside and will attack the outside with wire brush tomorrow and paint
Peace for now!