"The Diagnostic routine shown above will be discontinued when engine rpm exceeds 3000" If that's true for an M42, I don't think I've completed a drive cycle since I bought the car! Since they don't make any real power below 3500... heh For obd2, I've always found that the SES light resets immediately when I clear it, and then if the fault redetects, it lights again. The 'Shadow' faults remain for some time, as the drive cycle doc shows, but then clear after a while. This is with BMW Scanner 1.41 t Last edited by TobyB; 05-16-2016 at 08:05 PM. |