318ti.org forum - View Single Post

pdxmotorhead · 01-29-2010, 07:21 PM

I work part time at a race shop that builds race cars.....

I need ot look , but I used some fittings a while back that were right angle swivels that went directly into the setrab cooler and had AN6 or 8 lines on them.... Hmm. Gotta do some research at the shop when I have some time.

Looking at the MOCAL plat I'm pretty sure I could machine a block of Aluminum with the exits to the rear, would be a possibility... Gonna have to look at that some more....

Dave

01-29-2010, 07:21 PM	#68
pdxmotorhead Senior Member Join Date: Mar 2005 Location: Portland Or Posts: 2,666 iTrader: (1) Photo Gallery	I work part time at a race shop that builds race cars..... I need ot look , but I used some fittings a while back that were right angle swivels that went directly into the setrab cooler and had AN6 or 8 lines on them.... Hmm. Gotta do some research at the shop when I have some time. Looking at the MOCAL plat I'm pretty sure I could machine a block of Aluminum with the exits to the rear, would be a possibility... Gonna have to look at that some more.... Dave __________________ Dave - PDX 1995 318ti - Active Black and Tan. 2005 330xi - Mtech 1 - 6spd - Orient Blue/Black