I did some measurements with my new digital caliper (of course they might not be 100% right but pretty darn close)
7.47mm height
12.43mm height to notch things
24.04mm outer distance from ends of notch things
12.68mm inner distance from ends of notch things
7.74mm width of outer notch things
4.38mm width of inner notch things
35.22mm outer diameter of gear (at ends of splines)
30.98mm outer diameter of gear (without splines)
24.46mm inner diameter of gear
2.37mm inner diameter of spindle
12.25mm outer diamter of spindle
37 teeth
6.30mm to tapered edge
7.65mm to top edge
1.72mm tooth width at gear
1.0mm tooth width at outer edge
I know I used odd terminology, and I don't have the angle of the teeth and the depth of the indentation that the two notch things go into, but maybe someone with more experience with CAD would be able to take a look at the gear and could build a CAD drawing for it. |