View Single Post
Old 05-03-2011, 03:51 AM   #127
Eric
Senior Member
 
Eric's Avatar
 
Join Date: Jul 2004
Location: Hudson Valley
Posts: 229
iTrader: (3)
Default

There is one that is way down inside the rubber part - you can't see it, you can only feel it. I assume that's the one in question ...

I would carefully trial-fit every darn tool you've got - different Torx sizes, Phillips head, and standard screwdrivers. Remember that the hole in the rubber, and the tunnel it passes through, may not be lined up perfectly with the fastener at the bottom, so you may have to poke around a bit to find the center of the screw. Once you get it, you'll know it. If it doesn't quite feel right, then try a different tool, until it "hooks up" solidly.

- Eric
Eric is offline   Reply With Quote