View Single Post
Old 04-20-2011, 06:30 PM   #16
blowin 4
Senior Member
 
blowin 4's Avatar
 
Join Date: Feb 2009
Location: san jose
Posts: 425
iTrader: (0)
Default

Quote:
Originally Posted by blowin 4 View Post
my start is about 3 weeks old its oem .2 last things im going to try there are to sensor on the head one is cold start injector already changed then there is the hot temp sending unit i dont think that matter but im going to change it . 2nd new coils cause one set is eom but used 2nd set is aftermarket but older could have went bad ..i noticed all coils read .6 ohms cold but when i test them hot the jump from .7-8 -9 ohms never a steady # back in forth from .7-.8 . 9 could 2 sets of coils be bad ... if that dont work tracing wiring into dash and ignition cylinder.
i think i found the prooblem when switching from one ecu to an other car start up every time a i think i have to bad ecu cause engine is warm fires up every time as soon as i the ecu starts to heat up car will have start problems both ecus from ebay 70 bucks ea i need a test vechice.
OK so installed cold ecu car fires up 20 times swap back to hot ecu car floods wont start swap back cold ecu car starts fine engine hot soon as cold ecu get warn i get the same problem 2 bad ecu wtf ebay that explains why the last ecu i got from ebay had some chip that looked after market and the tabs looked pride open and for the orinal ecu i think i screwed it up for forgeting to shut off the key a couple times over night must have fried the resisters cuz my icv was stuck like it had heat froze ...

Last edited by blowin 4; 04-20-2011 at 06:51 PM.
blowin 4 is offline   Reply With Quote