Quote:
Originally Posted by lpcapital  I would just make 2 simulators: one per O2 sensor and call it a day. There's enough room on the board to make them fit them in a single box, already sharing ground and 12V inside the box. You'll end up with 6 wires instead of 4: 1 for ground, one for 12v, 2 for O2 (one per sensor) and 2 for DME (one per sensor)... |
I have a DIY for this I'm sure because it was used in the I-4 to I-6 swap manual. It is on this board. If not I will email it too you. Ipcapitol is correct you just make two on one board, the only shared item is the regulator
Edit ~ It's right here ~
http://www.318ti.org/forum/showthread.php?t=24726