[paul somlo]

Originally Posted by fast_frizz

i made a tool to put the seal at the same depth as the original ones: https://www.thingiverse.com/thing:4754427

Very good, Fritz - did you 3D print it?

Truthfully, I don't even remember posting this, been a while. Right now, the 'ti is laid up in the garage; I had a crank no start condition, and no pressure at the injector rail. I replaced the fuel pump, regulator, and fuel filter. Plenty of pressure at the rail now, but still no start. Hard to believe two unrelated component failures. Pulled some spark plugs, completely dry - it appears that I've got an electrical problem to chase.