View Single Post
Old 12-15-2011, 05:30 PM   #15
RCV7
Senior Member
 
Join Date: Feb 2011
Location: NJ USA
Posts: 159
Vehicles
iTrader: (1)
Arrow More help needed

Alright, so I tried fitting an e36 325/328 hubs but they did not fit, neither did the smaller ti hubs. So I'm back to square one: Wheels are sticking out further than the wheel wells/fenders with the wider Z3 hubs. Remember, I have the whole Z3 sub frame assembly. The rear wheels on the car now are the SSR Comps with a whopping +44 offset. Any suggestions? I really haven't seen any larger offset than what I already have. I'll post a picture from above so you can see how much it sticks out. I would have to not only roll the fenders but also pull. I need 3/4 to 1 inch of clearance to not rub. Thanks in advance with any ideas.


Quote:
Originally Posted by RCV7 View Post
Pretty sure it's just the hubs. They appear to be about 1.5 inches wider that the ti's. I took the car to Bill at Bimmerclinic here in NJ and he told me the same thing. Will be swapping them out in the next week.

Last edited by RCV7; 12-15-2011 at 05:32 PM.
RCV7 is offline   Reply With Quote