Wow I'm lost after this post too much info combined. Change or check youheadtemp sendor, and check cold cranking volt to ensure they are the same as hot cranking volts to eliminate the volt issue...
JohnS
Quote:
Originally Posted by blowin 4 my start is about 3 weeks old its oem .2 last things im going to try there are to sensor on the head one is cold start injector already changed then there is the hot temp sending unit i dont think that matter but im going to change it . 2nd new coils cause one set is eom but used 2nd set is aftermarket but older could have went bad ..i noticed all coils read .6 ohms cold but when i test them hot the jump from .7-8 -9 ohms never a steady # back in forth from .7-.8 . 9 could 2 sets of coils be bad ... if that dont work tracing wiring into dash and ignition cylinder. |