View Single Post
Old 05-22-2008, 10:24 PM   #6
M4YTY
Senior Member
 
M4YTY's Avatar
 
Join Date: Nov 2007
Location: Newcastle UK !BMW TECH!
Posts: 110
iTrader: (0)
Default

Quote:
Originally Posted by Philly View Post
for mine, when i tightened all the header bolts, it drew it up right tight to the tunnel and barely budges, then when i put my catback on, I used stiff ruber hangars on the muffler and the exhaust moves around less than it did with the stocker system under there...
Thats the same situation im in. I bought the two little brackets and rubbers but the exhaust sits too high to use tem. I am a bit worried about the stress on the headers but as mentioned the exhaust sits too high in the tunnel to use them. Thats why a asked the question. I presume they bolt on using the lower bolts for the tunnel support right? its held up with bits of wire for now till i can get it on a lift at work. Axel stands are just not high enough to get a proper look at the system. Strange!
M4YTY is offline   Reply With Quote