318ti.org forum - View Single Post - CA Cat-back exhaust w/ Magnaflow stainless muffler

zoner · 01-23-2011, 01:54 AM

This had just been installed on my car when I bought it from the PO. Drove around with it for about a year and realized that it was just a little too loud for me (it is a free flowing exhaust, after all) at freeway speed, so I replaced it with an OEM Eberspacher cat-back. It's set up for a 318ti, but will need to either be welded directly to the back of the cat, or have a flange welded on to make it a true bolt-on to a stock system. I would prefer to sell it locally, as shipping this will probably not be cheap or convenient.

Magnaflow stainless muffler w/ 3.5" O.D. stainless round tip (fits perfectly into stock bumper cutout); free-flow resonator; 2.25" pipe and inlet... pipe has correct crimp/bend to clear the axle (see photo). SOLD!

PM or email me with additional questions or to set an appt. to come pick it up!

01-23-2011, 01:54 AM	#1
zoner Senior Member Join Date: Oct 2008 Location: Los Angeles, CA Posts: 1,464 iTrader: (7) Photo Gallery	Cat-back exhaust w/ Magnaflow stainless muffler This had just been installed on my car when I bought it from the PO. Drove around with it for about a year and realized that it was just a little too loud for me (it is a free flowing exhaust, after all) at freeway speed, so I replaced it with an OEM Eberspacher cat-back. It's set up for a 318ti, but will need to either be welded directly to the back of the cat, or have a flange welded on to make it a true bolt-on to a stock system. I would prefer to sell it locally, as shipping this will probably not be cheap or convenient. Magnaflow stainless muffler w/ 3.5" O.D. stainless round tip (fits perfectly into stock bumper cutout); free-flow resonator; 2.25" pipe and inlet... pipe has correct crimp/bend to clear the axle (see photo). SOLD! PM or email me with additional questions or to set an appt. to come pick it up! Last edited by zoner; 03-09-2011 at 07:28 AM. Reason: Item sold!