Next I installed that bugger of a hard line and connected the soft line.
Flywheel and clutch time! Using new bolts, bolt the flywheel into place. The torque value is very high and it needed a tool to hold the flywheel from turning. I used a piece of flat steel with a couple hole drilled in it, as seen in the PelicanParts.com clutch replacement guide.
New clutch! Carefully degrease the pressure plate surface with brake cleaner
After degreasing the clutch surface with brake cleaner, install the clutch disc using the clutch alignment tool.
Then install the pressure plate using new bolts. The bolts draw the pressure plate to the flywheel since you are pushing against the pressure plate springs.
