Quote:
Originally Posted by Deeznutz  So i just finished my swap that i started last year my build thread here http://www.318ti.org/forum/showthread.php?t=41996 i too have no working abs and can't figure out why because it worked before the swap when it had m44 in car. Now i have no abs so can you please clarify where in car you traced those signal wires to/from also i have aftermarket tune so no CEL for emissions equip, but i really want my abs to work. also are you certain abs is functioning have you road tested it? My ABS light come on few seconds after engine is running my car is 97ti with s50b30 using 97m52 auto harness and 97m52 ecu. |
It is unlikely your problem is the same as Dan's since his car had wires cut by the previous owner.
The ABS light will be on if the stepper motor is not connected to the old M44 Throttlebody ASC unit. I read a post somewhere that said you could use a resistor in place of connecting the motor but the ABS light will be on if that is not connected.
That's the first thing I would check anyway. Good luck