318ti.org forum - View Single Post - Expert opinion needed regarding cam timing

b.u.ti-ful · 04-09-2009, 11:26 PM

Is it just the verticals that need to be set?

If so, can you just cut your notches deeper to allow the tool to drop down?

04-09-2009, 11:26 PM	#4
b.u.ti-ful Senior Member Join Date: Sep 2006 Location: Wisconsin Posts: 1,895 iTrader: (1) Photo Gallery	Is it just the verticals that need to be set? If so, can you just cut your notches deeper to allow the tool to drop down? __________________ ... ʎɐqǝ uo pɹɐoqʎǝʞ ɐ ʎnq ı ǝɯıʇ ʇsɐן ǝɥʇ sı sıɥʇ