View Single Post
Old 04-30-2010, 07:13 AM   #14
CATELUS
Junior Member
 
Join Date: Oct 2009
Location: Perth - Australia
Posts: 12
iTrader: (0)
Default

Quote:
Originally Posted by wolferj View Post
It was basically the same process as the seats.

1. Serious cleaning / de-greasing.
2. Prep. Light sanding with coarser paper, then finer grit, and finish with very fine grit. Clean all areas well, leaving no fuzz or dust.
3. Filled the pitted areas with the filler product, then a top coat of the filler for an even surface.
4. Very light sanding of the filler product after it cured for a smooth finish. I used a scouring pad for all my final finish sanding.
5. Brush on the dye in several light coats.

Good luck!
Awesome.
Thanks for the feedback.
Just another question about it.
Did you sand back the whole wheel to give it an even finish or just the affected area?
CATELUS is offline   Reply With Quote