Lambda Emissions Control CEL Greeeetings! I have a 95 318ti active. I keep getting an intermittent check engine light. I have the peak scanner tool and the chart says it is the emissions lambda control. I searched through here but didn't find much information and couldn't find much in the Bentley Manual...anyone have any insight as to what this could be? I read on here that the o2 sensor is a lambda sensor...but there is a seperate fault code for the o2 sensor so I am not sure what this means. On a side note, the CEL only comes on when my foot is off the gas pedal. If I idle for a little bit, it will come on. If I am driving and take my foot off the pedal, it comes on. The instant I tap the gas pedal at all the light goes off. I also have a code for knock cylinders 3/4 which I had replaced that sensor about 2 years ago so I would hope it is not bad again! Maybe the 2 codes are related? -Rob Thanks! __________________ 1995 318ti Active Pioneer Speakers [] Aluminum Billet door locks [] ACS Pedals/Deadrest [] ACS Shift Knob / E-Brake Handle [] Clear Corners/Tails/Sides [] Sylvania Exterior Lighting [] Custom CAI [] Dinan Engine Chip [] Dinan Transmission Chip [] H&R Race Springs [] Tokico Illumina Shocks [] BMW X-Brace [] Relocated Lighter Mod [] Custom iPod Mod http://www.cardomain.com/id/robcarync |