So I got the replies I was looking for in a Facebook group. I figured I'd post the responses I got here, in case someone else is looking up this information in the future.
Quote:
If I remember right it'll bolt right up, only thing is with the master cylinder designed for the Getreg you'll have a stiffer pedal with the ZF. Other than that if you get all that stuff you should be good. |
Quote:
Yes, it works. The slave needs to match the pressure plate. The flywheels and clutch kit should be matched for the transmission. Starter should work as is. |
Quote:
The hydraulics will work, just may be stiffer pedal depending on the pressure plate you use. I ran my s52 swap for a long time with the stock master and slave, was just kinds stiff because the pressure plate is stiff. But with a 325i clutch it should work better |
Quote:
All non-m masters and slaves are the same. The 92 had a different master. The s50/2 slave is different in piston bore. Stock will be fine. If you use an s50/2 clutch with non-m slave it will be very heavy at the clutch pedal and initiates right off the floor. It's all bolt in but you need the linkage from the zf for the guibo and shifter location. |
Thanks to the guys in the 318ti
Facebook discussion group. Looks like if you go to do this swap yourself, it should work, just be a great deal heavier on the clutch.