epiphany swap

[Crashaddict]

Finally got some time with a drill press. i was able to do a preliminary intercooler mount with 26 inches of 1/4 inch 90 degree aluminum, waiting for the radiator support to get back from paint before i start running pipe.


you can also see the new waterpump....no biggie
ahh the things a day off work can do for you

[Crashaddict]

updates:
1.ordered 2 mocal 2 core 19 row oil coolers today(god these are expensive)
2.bought a 16 inch slim radiator fan
3.installed the mishimoto racing thermostat
4.took a measurement for the driveshaft(should be done next week)
5.installed that freshly restored alternator

here is a picture of goingson under the hood

let me know what you think, this thread has been crickets for a while now

[trikzta]

Dude can't wait to see it running I just bought another ti and can't wait to do a meet

[Crashaddict]

Originally Posted by trikzta

Dude can't wait to see it running I just bought another ti and can't wait to do a meet

getting close, cant wait to unveil her

[trikzta]

I know yours is going to look hot mine is still in the works not doing a swap or nothing but I bought her as a fender bender So fixing a lot on it almost doe with the exterior still needs some work in the inside

[Crashaddict]

Originally Posted by trikzta

I know yours is going to look hot mine is still in the works not doing a swap or nothing but I bought her as a fender bender So fixing a lot on it almost doe with the exterior still needs some work in the inside

looks good in the sig, are those wheels powdercoated or did you spray em yourself?

[trikzta]

Lol dude that ti was totalled 6 months ago

[Crashaddict]

Originally Posted by trikzta

Lol dude that ti was totalled 6 months ago

lol, my bad, didnt know, did you keep the wheels?

[trikzta]

Yeah but one got pretty banged up in the accident

[Crashaddict]

*Question withdrawn* the part i was looking for was 63 12 1 387 026

looking purty

[Bobtail_Bimmer]

Try realoem.com and look at the diagrams. It should have it and give you the part number.

[Crashaddict]

Originally Posted by Bobtail_Bimmer

Try realoem.com and look at the diagrams. It should have it and give you the part number.

haha ive been looking, and while looking for part numbers on ebay to find the right diagram, i actually found the part i was looking for

[Crashaddict]

brand spanking new driveshaft

oil coolers came in today: Mocal 2 core 19 row

daily update

[Crashaddict]

Anybody familiar with the fuel level sending unit in our cars? I need to make a new cluster, but have heard that 2 sending units are used making it very difficult for a simple gauge to read, any advice/solutions would be very much appreciated.
I was considering using glowshift components for my tach and Speedo and the plx dm100 for additional information such as. Boost, fluid temps etc, but am at a loss for what to do about a fuel gauge.
It doesn't have to be in the dash either, I've heard vague mentions of a unit called an arduino that may be able to replace the area where the obc screen currently sits. Don't know much about how it works, but please chime in if you have knowledge of such things

[Crashaddict]

*BUMP* pulling my hair out over this fuel sender issue. anybody got any advice?