Who has installed DASC? What did you do with that wire?

[Lbcnu24]

Hey gentlemen,

I need some advice and some serious information as to where the DISA Valve signal retrieving wire may have went to on the M44 motor. I need to know which pin out on the DME is for that special necessary wire. I don't know where to find a diagram either.

you see, my car used to have a DASC or some other kind, then they parted the car, once I got it, I basically restored the car. meanwhile, the car runs like caca once in a turd while. As of now, I cannot locate that signal wire. There is a ground wire, that is all. So i plan to run a new wire if I can figure where it goes, to the DME or what?

any information would be helpful to me, thanks in advance!

[Sweepy]

http://wedophones.com/Manuals/BMW/19...g%20Manual.pdf

Page 85
I think you mean the intake resonance change over valve looks like one pin is dme pin 58 blue white but the other pin seems to go in to a red white multiple connection branching off to alsorts so I would assume this is your common power supply and the disa is switched to earth by dme on pin 58