Good idea! I just did a major overhaul on my cooling system; EVERYTHING except the heater core but I got a bit carried away and replaced all the hard-to-get-to sensors as well. I was going to "fix" the harness too; especially lengthen the alt. wiring but didn't get a used harness in time. Next is to figure out how to get a screen behind the DISA so when it blows up it won't destroy the head or something like that.... there's lots of things to do on that side of the engine as well; that sensor harness can be re-routed, throttle cable support slotted, and removing the valve cover makes it a lot easier to get the rear plastic fitting off, et, etc Last edited by urbanmisfit; 12-04-2011 at 07:55 PM. |