WTB- Passenger side motor mount heat shield When I broke the stock motor mounts the shop I was using at the time installed my IE motor mounts. They removed and threw away the stock heat shield that goes around the motor mount on the passenger side. I believe the design of the IE mounts doesn't allow for the stock heat shield to fit. My IE mounts are starting to deform from heat damage, so I'm replacing them with the Vorshlag units which allow the stock heat shield to be used. So I'm looking for somebody that has done a swap and has one laying around for cheap. It is a cheap part at the dealer, so not looking to spend more than a few dollars + shipping. The part is only available from Germany, so I'm looking at over a month to order from the dealer. Word of advice, don't run urethane motor mounts without some type of heat shielding between the ex.manifold and the motor mount. Part #51488173388 Last edited by mohaughn; 12-15-2009 at 05:07 PM. |