OBD 2 S52 INTO 95 Clubsport

[Jnoronbmws]

I am in the middle of swapping a full 97 S52 setup with OBD2 into my 95 clusport ti. Again I will be keeping the OBD2 set up. I have the complete 97 M3 and all the parts i need.

I cannot seem to find anyone on here that has retained the OBD2 into an OBD1 318ti. I have seen plenty of E30 though. If anyone could point me in the right direction for that it would be great. Looking for wiring info. I can figure out myself but any tips would be helpful.

Current set up is 97 M3 engine and trans, with M50 manifold swap kit,jbe lightweight flywheel and M5 clutch, upgraded engine mounts and trans mounts, long tube headers, TRM will be doing the ECU flash.

The ti has M3 style Koni suspension, H&R springs, stainless brake and clutch lines, M3 sways front and rear, M3 spindles and E46 brakes in the front.

Been slowly working on this for a year now. I finally got everything I need. Ill get more pics up tomorrow.

[Jnoronbmws]

Got a little sidetracked on getting this stuff posted. Any way the M3 was stripped of all needed parts. The ti engine was removed and engine bay cleaned. The S52 got a gasket refresh along with UUC E34 flywheel clutch set up, SS clutch line, and UUC mount for trans. Headers were installed and I set the S52 in last night.

The ti interior is all gone and I lined the floor after removing all sound deadening material. Waiting on custom aluminum door panels. The sunroof cassette was deleted and the sunroof panel fix mounted. I have my seat sliders ready to go in just waiting on the seats.

Relocated the battery to the trunk using the harness and jump point from the M3, pretty slick that it is already set up for it.

Any way here are some pics of whats been going on.

[Jnoronbmws]

And a few more

[ALPINEMTECH98]

https://www.youtube.com/watch?v=Qvyno7ARKaM

bluebimma seems to be very good on those, but he did a OBD I conversion so idk how you going to do a OBD II swapped into an OBD I car : / sorry

[Jnoronbmws]

After a few hours of looking at diagrams I believe I have it all figured out. I am about to go out and finish up the wiring now. Hope to fire the engine by the end of the week