318ti.org forum

Go Back   318ti.org forum > Technical, Maintenance and Modifications > Knowledge Base


Knowledge Base How to articles and things explained.

» Recent Threads
The 318ti OBD-II engine...
10-19-2006 06:48 PM
Last post by J!m
09-24-2023 12:44 PM
199 Comments, 250,030 Views
318 ti california top
09-18-2023 09:56 PM
Last post by davidjames
09-23-2023 06:46 PM
4 Comments, 969 Views
318ti AMR500 ...
06-09-2023 09:43 PM
Last post by Ultraviolet
09-22-2023 10:21 PM
29 Comments, 22,524 Views
Headlight switch...
11-06-2012 06:33 PM
Last post by furutani
09-21-2023 04:50 AM
14 Comments, 9,965 Views
1995 318ti 41,000mi...
09-17-2023 02:52 PM
Last post by yobayn
09-17-2023 09:49 PM
1 Comments, 780 Views
Comment Share/Bookmark
Tutorial Tools Display Modes
Old 01-14-2008, 08:48 PM  
Junior Member
Join Date: Jan 2008
Location: boston
Posts: 24
iTrader: (0)
Default DIY Starter replacement - with PICs

In a prior thread (see “Can I access my starter bolt from the radio slot?”) two ways to get to the starter bolts were discussed: 1) Remove the intake manifold, or 2) Drop the shaft/exhaust, loosen the transmission brace and tilt down the engine/transmission slightly to access starter from the...
540318 is offline   Reply With Quote
By ald0725AIM on 02-19-2015, 04:57 PM

540318, great pictures. I realized that its going to be difficult to access so I decided to attack from the top taking the top and bottom manifold. I'm stuck with the bottom manifold trying to figure out how to disconnect all the wirings connected to the wire loom that is placed in the middle of the lower manifold. I wish I can slide the whole thing but its not possible.
Reply With Quote
By ZRXwannabe on 02-29-2016, 01:09 AM

So I thought I would put my 2 cents in on this also. I did my starter on my 96 318Ti yesterday. I did almost the whole thing from under the car. My first step was of course putting the car on jack stands. Then disconnect the neg. battery post. Then I pulled the dipstick and tube. This can be a little challenging but it does come out and is worth the extra room. Then I went under from the passenger side. I found this the easiest to get up to the wires and undo the 13 mm heavy gauge wires and the 10 mm nut holding the other visible wire. Then I moved and came in head fist from the front of the car and used about 18 inches of extensions, a universal (swivel) extension, and the e12 socket. Going up along the transmission with the extensions in my right hand, and reaching up around the side of the engine with my left I guided the socket on to the lower bolt. I ended up needing 1/2 inch drive because the bolt was so tight. Then I put a jack under the transmission cross member, unbolted the 4 bolts holding it up, and lowered it down about 3 inches or so. This gives enough room to get in there with the ratchet and extensions. With the bolts out I pried the starter loose from above with a long thin flat tip screwdriver. Then back below to rotate the starter far enough to take off the last nut and wire. This is an 8 mm nut. Installation is pretty much the reverse. Small wire first, then rotate starter into place, tighten bolts, install other two wires, jack tranny back up and install four bolts holding mount, install dip stick and tube. A trick I used on this was once dip stick is started, insert a screw driver in the tube up to the handle and then tap LIGHTLY on it to drive tube in. Reconnect battery, and start. This took me about 2 and a half hours but a good 30-45 minutes figuring out how to get to things. I think if I had to do another I could do it in 60-90 minutes.
Reply With Quote
By bcp on 02-01-2023, 01:33 PM

Reply With Quote


Currently Active Users Viewing This Tutorial: 1 (0 members and 1 guests)
Tutorial Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump

Similar Threads
Tutorial Tutorial Starter Category Comments Last Post
FS: 1995 Alpine White 318ti Sport Package 95ti_santabarbara US and North America 19 10-28-2008 02:28 PM
'97 318ti 5-spd, white, Active, 103k miles in Virginia Phil Marx US and North America 12 04-24-2008 03:40 AM
White or Black out? BmWwHiPPin Exterior 8 01-25-2006 07:09 PM
White ti sighting Juni New England - US 5 11-22-2005 03:43 PM
White Ti on Trapelo Rd (Waltham,Ma) Tyler Misc 4 10-03-2005 07:09 PM

All times are GMT +1. The time now is 06:39 PM.

Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2023, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2023, 318ti.org

Tutorial powered by GARS 2.1.8m ©2005-2006
© vBadvanced CMPS v3.2.2
[page compression: 65.92 k/79.29 k (16.86%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.