318ti.org forum

Go Back   318ti.org forum > Technical, Maintenance and Modifications > Engine

Notices

Engine Tuneups, chips, wires, spark plugs.

.
» Recent Threads
1999 M-Sport For Sale
12-31-2023 05:10 PM
Last post by Coop540iT
03-23-2024 06:39 PM
1 Replies, 98,692 Views
Once again 318ti owner...
03-20-2024 12:39 PM
Last post by two30grain
03-22-2024 02:04 PM
1 Replies, 61,545 Views
What brakes do I...
03-20-2024 03:27 PM
Last post by huirtera
03-20-2024 03:27 PM
0 Replies, 58,926 Views
Reply Share/Bookmark
 
Thread Tools Display Modes
Old 08-03-2022, 06:15 PM   #1
far6car
Junior Member
 
Join Date: Nov 2018
Location: Ohio
Posts: 1
iTrader: (0)
Default checking for cracks in the block

The engine overheated. 204000 miles. The rear plastic coolant hose connection broke and coolant lost. I had the head removed and found a blown head gasket. Head gasket replaced, head surfaced .011, complete machine shop head rebuild, new valves and valve seals, head checked for cracks, none found, new head bolts. checked the block visually and with a straight edge, light sanded the block surface.
After reassembly, drove for 2 days, and overheated again. Had the coolant checked and found exhaust gas in the coolant. Will boil the coolant out after about 10 minutes of running. Also found crankcase vent valve not working.
I am resigned to taking the head off again. Is there a way to check the block for cracks without taking it to a machine shop and disassembling the block?
far6car is offline   Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
M50 Swap with Free M54 Block and Rotating assembly NeoMishMoo Engine 1 06-11-2016 01:09 PM
Flushing the Block During a Cooling System Rebuild uncledavid Lounge 2 03-21-2014 02:03 AM
M44 Block Warp? MikeLiv Engine 2 03-22-2012 07:23 PM
Oil leak and rubber block tyminski Engine 4 02-08-2011 03:31 PM
MN M44 Parts/M50 Non Vanos Head/E34 M50 Block mphmotorwerks US and North America 3 05-16-2010 03:25 PM


All times are GMT +1. The time now is 05:29 PM.


.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org
© vBadvanced CMPS v3.2.2
[page compression: 56.45 k/64.67 k (12.71%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.