Different DASC Pulley

[hitman637]

Pulleyboys.com have smaller pulleys for the 318is with 6 grooves, which I assume is the same fit for the 318ti's on the DASC.

I have a 318i and it only has 4 grooves on the stock pulley. Where can I get a smaller pulley for my DASC application?

Thanks in Advance.

[DustenT]

Originally Posted by hitman637

Pulleyboys.com have smaller pulleys for the 318is with 6 grooves, which I assume is the same fit for the 318ti's on the DASC.

I have a 318i and it only has 4 grooves on the stock pulley. Where can I get a smaller pulley for my DASC application?

Thanks in Advance.

Call Pulley Boys and ask them. I got mine from them.

[hitman637]

Thanks. I actually had called pulley boys before posting this question. I was told that they did not have what I was looking for.

I'm hoping someone here has run into my situation and found a solution. Thank you.

[DustenT]

Originally Posted by hitman637

Thanks. I actually had called pulley boys before posting this question. I was told that they did not have what I was looking for.

I'm hoping someone here has run into my situation and found a solution. Thank you.

As far as I know they are the only ones that make them. Track down ZeroG (chad) and as him about it. He is the one that originally setup things with Pulleyboys and he might have some ideas.

[hitman637]

Thanks. I'll try to contact him.