Questions about the Rear Bearing and E30 Halfshaft?

[Cutie_Pinoy]

Do anybody know where can i get the rear bearing? and what the part numbers?? sorry for the noob questions, i just bought a 3.73 limited slip from 1987 325e i think and how do i know if i have a abs in my 318ti. If i do then where do i look for? If i don't will the e30 halfshaft w/abs will fit on the 318ti without no problem?? I've been reading all the Differential Thread and don't see anything about it. by the way i have a 97 318ti Base model i think.

[larryn]

You have antilock braking in your car. It was standard equipment.

The e30 half shafts you will be installing will need to be from a e30 that had abs. The way you can tell is an extra set of splines near the wheel side of the shaft, as seen in this pic (it compares the ABS section on the two halfshafts):


As far as part numbers go for bearings. Look them up on RealOEM.com.

[Cutie_Pinoy]

i just didn't know if i had abs or not. At least now i know that i have one cause i wasn't sure if it's was an optional or standard. thanks for the help