Water meth kit on m44 no boost .

[dguzzardo22]

Is it practical to use my small kit on my m44 and hook it up to a push button activate and only use it after 5k or 4k . Or would it be a waste ?

[3.2TI]

WASTE!

[trikzta]

Originally Posted by 3.2TI

WASTE!

+1

[slow_ti]

What he and he said ^

[trikzta]

not really a reason to have meth shots on a engine that is not FI

[bmwconnect]

Originally Posted by dguzzardo22

Is it practical to use my small kit on my m44 and hook it up to a push button activate and only use it after 5k or 4k . Or would it be a waste ?

NOS would be a much better investment if you plan on spraying something into your intake stream while naturally aspirated

cheers

[dguzzardo22]

Thanks . I seen on my kit it says for all na and turbo so I just curious .

[3.2TI]

No doubt you can install it, whether you will gain anything out of it is another story. The kit is mostly for cooling the engine but doubt the stock m44 needs it. a simple air intake will do fine.

[urbanmisfit]

the best ones I've seen use injectors in the intake and are sync'ed to to the fuel injection/ign via a controller. A lot of Mazda 1.8 DOHC NA guys use them.
I'd be careful as to how much you inject at first though.

[dguzzardo22]

I had a scion tc with a turbonetics turbo and I bought it then . It has a adjustable boost controller to activate it but I was just gonna run it to a push button . I would like to get a turbo for it I'm waiting on that thread with the full kit so I can just buy everything at once .

[JimLev]

Originally Posted by dguzzardo22

Is it practical to use my small kit on my m44 and hook it up to a push button activate and only use it after 5k or 4k . Or would it be a waste ?

I'm new here, saw a link on another forum about a mod to remove the secondary air pump without getting a CEL.
----------------
About all water/methanol will do for you is clean the carbon off the tops of the pistons. Probably a good thing, just use a very small oriface. You will have to run it for a while to get it to get the carbon off, it's really the steam that softens it up.
I'm running water/meth on my 5 series, I have nitrous and put it in to make sure I didn't have any detonation problems. There is no mechanical way of retarding the timing, so I installed this just to make sure the pistons didn't melt.