 No clutch Feel! Removed Tranny and reinstalled
I did all seals for the car. Rear main, front, timing cover gaskets, oil filter housing gasket. To do the rear, I removed the D-shaft and replaced all the rear bushings while there.
Reinstalled the clutch and now there is NO FEEL from the clutch pedal. I can push it to the floor and it springs back up in a floppy form. I did some research and I am thinking that my pilot bearing either did not mate properly during the install, or my throwout bearing is somehow misaligned.
Something certainly feels wrong. The car is still on stands, and thankfully turns on. However, when I rev the car to 2-3k on neautral, I hear an intermittent metal clanking noise in the engine/tranny area. It is a loud and violent noise. Not good at all. I shut down the car and never turned it on again. I think it has to do with the tranny not properly installed/aligned. Ideas? | 
Threaded Mode