s50 question

[1996 318ti NY]

are the exhasut studs the same diameter and thread as the intake manifold studs just shorter? they seem to have discontinued the itnake manifold nuts and i dont have any but they seem to be the same part number with the AM7 im hoping the are the same and i can use the ones from the exhaust otherwise idk what to do?

[1996 318ti NY]

anyone i need some insight here badly!

[wolferj-RIP]

Are you looking for intake manifold studs or nuts? You mention both, I can't tell which you are asking about...

[wolferj-RIP]

The nuts for the intake manifold are an 11mm hex with a 7mm interior fine thread. They are used in multipe locations in the intake system (MAF, throttle body, etc)

part # 07129905541

[1996 318ti NY]

wow they were under e30 parts i see would these also work as the exhaust manifold studs are 7mm also just the nuts the use are copper

http://www.pelicanparts.com/cgi-bin/...2D%39%39%29%20

[wolferj-RIP]

Yeah, Pelican still had the listing for the original discontinued part under e36, but listed the alternate part in multiple locations.

I actually scavanged my parts boxes to see if I had any floating around, but no luck... At least they're cheap...