Parting Out 332ti CA Edition, 300HP S52, project car part out

[raamaudio]

I have bought and sold a huge amount of parts over the years and always do my best to be as honest as I can, sometimes losing a sale when the part is 99-9% sure to be fine. On the rare occasion I have shipped off a part I bought used and did not test and it was not right when the buyer installed it I made it right for them, I was cheated but did not cheat the buyer. I used to make a great deal more money before I retired and could afford that but now retired and it would be harder to do so I am even more careful than ever as the only issues I have had were selling parts I thought were good but I was flat out lied to about when I bought them or they simply did not know.

Most of what I sell I know exactly what it is, if not I say so, honor and respect are worth everything to me, money is just a tool to get what I want and nothing more.

[raamaudio]

I still have a ton of great parts available, OBO, make that OBRO, or best reasonable offer

[blatant]

Bump for a good seller!
I want those schricks

[raamaudio]

Thanks

Nice cams, wish I had a use for the whole engine, I should be getting paid for it by tomorrow it seems though.

-------------

I am a bit surprised at how little I am getting interest on this 318ti site, sold quite a few things on the regular forums but not here.

I am willing to negotiate for reasonable prices of course.

And I ship asap, well packed, etc......

Good Day
Rick

[jdehaan]

So are the gauges still available?

[CosTick]

for the full set m-tech side moldings, how much shipped to 92106?

[raamaudio]

I still have all the gauges, I have a Cobb AP tuner/display due in today so when I get it hooked up I can check to be sure it will show the boost and oil temp and pressure well enough, if so then all are for sale.

I also have a 3 step programmable shift light from Autometer I love, it has a digital tach as well, the AP has a shift light but only seems to have one RPM setting. I need to check it out and might sell the Autometer one.

I used the gauges in stock radio location in a prior car and turned them all to where the needles point up at the temps, pressues, etc I want to see so just a glance is all that is needed.

I used the shift light settings to have one just under redline, 200 RPM, to help hold a gear on some straights so I could skip a shift up and right back down for a corner, this helps keep the car more stable and done right is faster and far easier, less chance of going off course. etc....

I then had a redline to shift at for normal shifts and an over red that shows up bright and flashing, it works fast enough that you can see if downshifted to far while letting out the clutch so you can press it back in and save from blowing the engine.

I find the shift light incredibly helpful on track, never have to look at the tach on the dash

I will likely keep it as so handy to use but the gauges most likely will all be sold, they are my favorite gauges made for quality, value, style and low weight. I have never been into super expensive gauges so I could brag about them

Please give me a little time to check the AP out to be sure what gauges I will be selling.

[raamaudio]

I still have the side moldings, I do not think I even opened the box they came in so I have to double check to be sure I inspected them.

How about $139 shipped, after I inspect them today to be sure they are good to go?

Thanks
Rick

[CosTick]

Sounds good Rick, do you accept paypal?

[raamaudio]

Great and I prefer PayPal, my ID is ram@raamaudio.com

I require a verified account, confirmed shipping address, insured and signature for delivery but can make adjustments to those requirements for certain situations.

Thanks
Rick

[CosTick]

Awesome, I'd prefer to wait a couple days just to ensure I don't have you ship them to the wrong place, as i am currently moving, however if they sell before then i understand.

-Colin

[raamaudio]

I have two audio systems, an S52 engine and other parts to go with it...all waiting a few days to ship for various reasons. I have shipped tens of thousands of packages so holding one here until you are ready is easy for me

[raamaudio]

More new and used parts added, more parts sold and shipped.....I need to update this thread and will after I finish packing parts and making some for a Vette audio system I sold.

BF.com has the updated listing.

[raamaudio]

MAJOR UPDATE:
Many parts sold, engine, etc.....

Starting a new thread on a very solid CA edition body with many parts.

[stevenwrichards]

Clutch / flywheel still available?