b-pillar removal?

[tiFreak]

I've just finished replacing my tan a and c pillars with black ones, I was going to do the b pillars too but I can't figure out how to get the little handle off that adjusts the seat belt height. anyone know how to remove it so that I can remove the b-pillar? on any other car I'd just pull as hard as I can and see what happens but I don't think I'll be doing that to my ti

[Xenocide]

broke my trying, LMK if you find out.

[Philly]

should have a small plastic cover clip over it, remove that, then you should see a nut - iirc its around 14mm or something.

Ive never done it, but lost the cover - so the nut is always looking me in the eye.

[Xenocide]

Nah not that one. Thats easy to get off, he is talking about the little level your pull to adjust the height of the set belt loop bracket.

[wolferj-RIP]

Brendan;
On the underside of the adjustment lever is a small hole. You need a very small flat screwdriver or similar object. There is a little catch in the hole that needs to be pushed up, releasing the adjustment lever allowing you to pull it straight off. Then you can get the b-pillar off...

[tiFreak]

thanks James, I'll try that tomorrow

[tiFreak]

that worked, all my pillars are black now, next step is the headliner

[lkwd318ti]

Originally Posted by tiFreak

that worked, all my pillars are black now, next step is the headliner

subscribed just in case i need to do this in the future.
I need to change my headliner too , can't open the sunroof.