MA ti motor, exhaust, etc.

[cpatstone]

Leftover bits from my 6cyl conversion. parts from 3/96 318ti. all prices OBO.

M44, 184k miles. Have disassembled motor. Bearing spun on #2 cylinder, IE at bottom of rod. Inside of bearing, facing the crank, was fine. crank is fine. Bottom of rod could be machined and fitted with a different bearing. It's not bad as-is. Block bores look as new (amazing for 184k miles). Head, intake, and most sensors gone. Still have ecu, complete/uncut harness, upgraded plug wires, etc.

aftermarket exhaust, complete. aftermarket 50-state high flow cat. magnaflow resonator. mandrel bent tubing. flowmaster muffler. a bit louder than stock. was causing CEL for post-cat sensor. uses stock mount points. $150. PO said he measured something like 10hp gain.

Tranny is fine, $300 because I'm not hugely motivated to sell it. Received regular maintenance.

Cooling system. Radiator approx one year old; balance 3 yrs old, so all in excellent condition. includes radiator, exp tank, shroud, fan... everything, really; didn't use anything in the swap. $200.

PM me for pix. have videos too. located in 01060. local pick up only unless it's easy to ship via USPS.

[cpatstone]

bump for an update

[318ti-redu]

Do you have the upper timing chain cover? Does it have the two nibs on the left hand side (if facing engine) to support the shut-off valve? If so, how much plus shipping to 91030?

PM me.

Thanks.