318ti.org forum

Go Back   318ti.org forum > Technical, Maintenance and Modifications > Electrical

Notices

Electrical All wiring questions.

.
» Recent Threads
looove
04-16-2024 01:18 PM
Last post by RichardBug
04-16-2024 01:18 PM
0 Replies, 1,268 Views
Brakes - soft pedal and...
04-14-2024 01:02 PM
Last post by bcp
04-14-2024 01:09 PM
1 Replies, 2,066 Views
lolita porn
04-13-2024 11:45 PM
Last post by Josephtus
04-13-2024 11:45 PM
0 Replies, 576 Views
lolita porn
04-13-2024 11:43 PM
Last post by Josephtus
04-13-2024 11:44 PM
1 Replies, 472 Views
lolita porn
04-13-2024 11:40 PM
Last post by Josephtus
04-13-2024 11:41 PM
1 Replies, 480 Views
lolita porn
04-13-2024 11:38 PM
Last post by Josephtus
04-13-2024 11:39 PM
1 Replies, 488 Views
lolita porn
04-13-2024 11:36 PM
Last post by Josephtus
04-13-2024 11:37 PM
1 Replies, 495 Views
lolita porn
04-13-2024 11:35 PM
Last post by Josephtus
04-13-2024 11:35 PM
0 Replies, 468 Views
lolita porn
04-13-2024 11:34 PM
Last post by Josephtus
04-13-2024 11:34 PM
0 Replies, 461 Views
lolita porn
04-13-2024 11:33 PM
Last post by Josephtus
04-13-2024 11:33 PM
0 Replies, 456 Views
Reply Share/Bookmark
 
Thread Tools Display Modes
Old 03-04-2009, 12:55 PM   #1
Popeye
Member
 
Popeye's Avatar
 
Join Date: Feb 2008
Location: Ontario, Canada
Posts: 67
iTrader: (0)
Default Front wiper stopped working - Question

Yes, I have searched the site.
For some time the front wiper has been slow (meaning not the usual vigor), kind of lazy. This morning it tried for the last time and died, so no movement at all in any position of the stalk (Switch). The car starts fine (so battery is good). Rear wipers work and windshield fluid is topped up. After searching this site i am hoping to change the "wiper control module", hope i am on the right track in troubleshooting this issue.

Could someone point me in the correct direction to the replacement procedure if available. thx.

The question is
Since the bitter cold set in the rear hatch lock does not want to turn anti clock wise to unlock the hatch, Yes i have WD40'd it and sprayed all kinds of oils in it, no luck. The same with the Driver side lock, refuses to turn anti clock wise to open but can lock the car (clockwise). I don't want to force it for fear of breaking something. The passenger side lock is just fine (both ways) and that's how i unlock the car now.
The question is are these two related, as i did read a post where it did allude to this relation.

1996 318Ti, no remote lock (I use the key), no alarm, have not installed anything aftermarket.

Thx in advance to your response.
Popeye is offline   Reply With Quote
Old 03-04-2009, 10:21 PM   #2
aceyx
Senior Member
 
aceyx's Avatar
 
Join Date: Aug 2004
Location: state college, pa
Posts: 3,431
iTrader: (0)
Default

Jiggle the key while turning. If that fixes your issue, your key may be worn. Search key with my username, there are a few posts on it.

Wiper could be the motor (bench test on a 12V circuit) or wiring (test continuity and resistance).
__________________
I scream, you scream, we all scream for ZOMBIES.
aceyx is offline   Reply With Quote
Old 03-05-2009, 12:51 PM   #3
Popeye
Member
 
Popeye's Avatar
 
Join Date: Feb 2008
Location: Ontario, Canada
Posts: 67
iTrader: (0)
Default

The solution for the Wiper issue was as follows,
1. Remove wiper arm (be careful when removing plastic cap to get at the nut)
2. Start engine and place wipers at full go
3. WD40 and assist the stub to turn
As it turned out that there was rust and gunk build up between the windshield trim and the stub. After 10 mins of this it was back to normal. No "Wiper Control Module" replacement.

Now for the key issue. Thx aceyx for the advice. The jiggling process did not work. I am thinking of getting a new key from the "dealership".
Popeye is offline   Reply With Quote
Old 03-05-2009, 04:21 PM   #4
aceyx
Senior Member
 
aceyx's Avatar
 
Join Date: Aug 2004
Location: state college, pa
Posts: 3,431
iTrader: (0)
Default

Test any of your other keys in the door first. Valet key (grey handle) will not work in the trunk.
__________________
I scream, you scream, we all scream for ZOMBIES.
aceyx is offline   Reply With Quote
Old 03-13-2009, 11:57 AM   #5
Popeye
Member
 
Popeye's Avatar
 
Join Date: Feb 2008
Location: Ontario, Canada
Posts: 67
iTrader: (0)
Default

Update on key issue
Received key from dealership and hatch and door(s) all work. So it turned out to be a worn out key ... sigh of relief
Popeye is offline   Reply With Quote
Old 03-20-2009, 06:29 PM   #6
aceyx
Senior Member
 
aceyx's Avatar
 
Join Date: Aug 2004
Location: state college, pa
Posts: 3,431
iTrader: (0)
Default

For future reference, don't use any wet lube in door locks. They attract and trap dust which expedites wear on parts. Graphite lube is what you want to use.
__________________
I scream, you scream, we all scream for ZOMBIES.
aceyx is offline   Reply With Quote
Old 04-22-2009, 05:26 PM   #7
s_menezes
Junior Member
 
Join Date: Jan 2009
Location: Miami
Posts: 13
iTrader: (0)
Default

Guys I am having same wiper issue. Mine is electrical. When I turn the car on (just the electricity .... radio/wipers are fine); but when I fully turn the key to ingnite the engine they turn-off just as the engine turns on! It's very strange. Thus I can drive fine; but without radio and wipers! Anyone with a suggestion, please?
s_menezes is offline   Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Help!! High rev when stopped oakley Engine 7 06-24-2008 05:23 PM
Rear wiper question. DueceMcCracken Exterior 2 05-20-2008 06:28 AM
Passenger side Headlight/FogLight stopped working? dunks Electrical 7 01-16-2006 07:30 AM
Quick question on my wiper arms... 318tiorteD Exterior 2 05-11-2005 03:52 AM
Windshield wiper fluid not working brosnan6 Exterior 12 12-24-2003 06:29 PM


All times are GMT +1. The time now is 07:13 PM.


.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org
© vBadvanced CMPS v3.2.2
[page compression: 88.26 k/104.51 k (15.54%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.