No-sale on eBay for this nice wheel... Make a REASONABLE offer...
I also have upper intake will all (good) sensors attached,
2 new oil filters (genuine BMW parts)
Sport front springs
Sport front sway (complete w/bushings and brackets you need to mount it)
Sport rear sway (complete, less end links unless I find them)
large stress bar (Sport used a larger diameter bar that is replaced by the X-brace by most. This is the larger diameter stress bar factory on the sport model)
Like new plastic under-radiator plastic tray (for sport if that matters)
Rear subframe (stripped) only the subframe with bushings installed- rust-free, no damage at all (if I cleaned it, it would look new!).
Half shafts (~63K miles)
Front calipers (both sides)
DME for 1998 ti sport
Wiring harness for above
Secondary air pump (might be for M3, might all be the same, have to check) I have at least two of these kicking around...
M42 air mass sensor
good front spindles/rotors (solid rotors) GONE M Roadster rear rotors (good, used)
New M3 windshield washer bottle (smaller than ti one)
New cap for above
M3 (dual-mass) flywheel, clutch, p-plate with 13K miles on it
Sweet ti cluster GONE New shift lever I THINK is a stock M3 shift lever. Bought so long ago I can't remember... Shorter than the stock ti one, but will hit the balancer unless linkage is bent to clear due to length below the 'ball'.
Various bits-n-bobs that I'm forgetting too...
ask if you neeed something and I'll look ALL parts are in great condition or new as specified. I don't have room for these
good parts; why would I keep the junk?
PM amd I will respond ASAFP