Trans Swap (need some extra input)

[wolfnacht]

Okay, Ive been away for some time now, had some issues with the Ti and finally got the goods to fix it...

Finally got a replacement transmission (to replace the one with bad syncros) and cleaned it all up, I know while doing this the clutch, while its all apart, is also a good thing to replace, which i have a Stage 1 SPEC clutch. Aslo i know its a good time to replace the obvious things. Heres a list of what about i figured i had needed.

1. Trans
2. Clutch kit
3. Throw out Bearing Guide sleave
4. Input Shaf Seal (trans)
5. flywheel/Rear Main seal (motor)
6. Pivot Pin and Clip
7. Shifter Bushings
8. Pressue Plate bolts(if needed)

I general got everything down, Just seeking some extra input on what i may need or not need, or how to or not to do something, or even any kind of reccomendations on where to obtain certain parts for decent price


Thanks everyone

[pdxmotorhead]

Slave cylinder maybe. Check the rubber boot to see if there is any fluid leaking around the piston.

Inspect the drive line while your under there, the rubber Guibo that acts as a U-joint gets old eventually.

I see you have guide sleeve but make sure the throwout bearing is on the list.

Dave