uk noob seeking 4 pot tips!

[m44lee]

thanks for all the comments guys

i'll be getting the pipercross back on soon and testing it on the rolling road too!

the lip for those interested was made by a guy on e36coupe.com
and then wrapped in real carbon by a guy on there also!

[m44lee]

well gave the car a good spruce for gaydon and then didnt go after a finding out how bad the inner edge of my rear tyre were this morning
but thought i'd put a few pics up anyway! before it went back in the garage until new tyres are fitted!









even spruced up the engine bay as i knew a few wanted to have a look!

[m44lee]

rolled the car out of the garage today just to fit a ac schnitzer carbon fibre strut brace! i had to bolt the throttle butterfly on the lower bolt so it cleared but all seems well!
however i couldnt bolt the brace down as the bolts i have on mine dont fit in the acs brace mounts but will get that sorted
and also refitted the carbon viper induction kit its pretty tight but it fitted however it needs a new hose as the old one is wrecked!







as always any comments good or bad are welcomed!

[screamin]

I noticed you have a tool in the APR in one of your photos. Did you do some tweaking to it along the way.

Good pics too !!

[slow_ti]

Your car is tooo dope dude


Sent from my iPhone using Tapatalk

[m44lee]

thanks for the comments guys

@screamin i dont know what pic you mean but i havent touched the rrfpr i'll leave that until it gets mapped properly in the next couple of months!

[slow_ti]

How much was your lip


Sent from my iPhone using Tapatalk

[m44lee]

Originally Posted by slow_ti

How much was your lip


Sent from my iPhone using Tapatalk

the lip itself was £100 (uk sterling)and then i paid about the same again to get it wrapped in real carbon fibre!

[slow_ti]

How much would it be In US dollars to get shipped from over there to here


Sent from my iPhone using Tapatalk

[m44lee]

Originally Posted by slow_ti

How much would it be In US dollars to get shipped from over there to here


Sent from my iPhone using Tapatalk

i have absolutely no idea mate

i can get you the email address of the guy that makes them if you'd like?

but the guy that does the carbon is a seperate bloke that i know through a few of the uk bmw forums

[tiFreak]

awesome looking strut bar, AC Schnitzer stuff is awesome

[slow_ti]

Sure. Post it on here cause my pm's are full


Sent from my iPhone using Tapatalk

[m44lee]

Originally Posted by slow_ti

Sure. Post it on here cause my pm's are full


Sent from my iPhone using Tapatalk

heres the guys email d.toddy@hotmail.co.uk.

[m44lee]

not updated this in a while so to bring it up to date

i've fitted a bbtb
pic for comparison



then so i dont ruin the hartges over winter i went for some style 24's





used 13mm hubcentric spacers and longer bolts to clear the coilovers

[m44lee]

also had my steering wheel retrimmed and some padding added
and also had some inserts done in carbon





also replaced the centre console as the old carbon one had gone a milky cloudy colour (from ebay) as a uv restistant resin hadnt been used

i also added another mirage piece (service reset cap)



and lastly i just finished fitting a blind into my rear parcel shelf


will post a pic 2morro once its fitted!