I'm looking to restore my newly acquired Club Sport to factory.
A very nice member gave me a stock radio several years ago.
It's been sitting on my shelf for this day since I've been too lazy to replace my 96 radio which it was originally intended for.
Anyway...
I pulled the aftermarket radio out.
I'm thankful that is was a clean install using an wiring adapter.
My replacement radio is missing the 2 securing small screws.
I'll pull them off my 96 radio since I was planning on replacing it with a blank DIN panel anyway.
I don't see where the screws would screw into.
Is it held in with pressure?