318ti.org forum

Go Back   318ti.org forum > Technical, Maintenance and Modifications > Suspension

Notices

Suspension Springs, sway bars, shocks.

.
» Recent Threads
The 318ti OBD-II engine...
10-19-2006 06:48 PM
Last post by Filiski120
04-24-2024 06:40 PM
210 Replies, 1,028,577 Views
Reply Share/Bookmark
 
Thread Tools Display Modes
Old 05-22-2010, 06:39 PM   #16
lysergicsurfer
Senior Member
 
Join Date: Dec 2008
Location: North Carolina
Posts: 190
iTrader: (0)
Default

I have had this kit installed since last september and it has been great so far. I recently checked all the ball joints and everything still feels new.

However since downgrading my suspension to the MZ3 setup, I removed these sway bar links to connect my sway bar to my strut. It may only be because I have a Racing Dynamics sway(28mm) but the sway links included with this kit were destroyed. I would recommend that anyone with this kit check them every 6 months or so. The ball joints on the links felt as if I could pull on the bolt and separate them, with tons of play and all the grease was dried up even though the boots were still ok. The rod in the rubber bushing was completely separated allowing the rod to drop out of the rubber when I removed the links from the car. The rod was allowed so much movement that half of the rubber was gone and the pressure started to bend the lollipop holding the bushing.

I still recommend the kit, just keep an eye out on the links.
lysergicsurfer is offline   Reply With Quote
Old 05-22-2010, 10:12 PM   #17
Bluebimma
Senior Member
 
Bluebimma's Avatar
 
Join Date: May 2006
Location: 43609
Posts: 3,425
iTrader: (8)
Default

Im using the stock sport sway, so far still together.
__________________
1995 Hellrot Clubsport 318ti -Gone
1996 Schwartz II Sport 357ti - 5.7L V8 LS1/6
1997 Moregrun Metallic 318ti - Gone

1998 Schwartz II sport 318ti - M50TUB25/5
Bluebimma is offline   Reply With Quote
Old 05-22-2010, 10:13 PM   #18
Bluebimma
Senior Member
 
Bluebimma's Avatar
 
Join Date: May 2006
Location: 43609
Posts: 3,425
iTrader: (8)
Default

Quote:
Originally Posted by AlphaVortex View Post
Just bought this package off eBay. I will try and figure out who made each of the parts. Hopefully I get lucky!
The brand names are written on the packages in the box.
__________________
1995 Hellrot Clubsport 318ti -Gone
1996 Schwartz II Sport 357ti - 5.7L V8 LS1/6
1997 Moregrun Metallic 318ti - Gone

1998 Schwartz II sport 318ti - M50TUB25/5
Bluebimma is offline   Reply With Quote
Old 06-04-2010, 01:47 AM   #19
Platanos
Senior Member
 
Platanos's Avatar
 
Join Date: May 2005
Location: PA
Posts: 1,906
iTrader: (5)
Default

link please
__________________
Platanos is offline   Reply With Quote
Old 06-04-2010, 02:04 AM   #20
Bluebimma
Senior Member
 
Bluebimma's Avatar
 
Join Date: May 2006
Location: 43609
Posts: 3,425
iTrader: (8)
Default

Ebay dude, link wont stay
__________________
1995 Hellrot Clubsport 318ti -Gone
1996 Schwartz II Sport 357ti - 5.7L V8 LS1/6
1997 Moregrun Metallic 318ti - Gone

1998 Schwartz II sport 318ti - M50TUB25/5
Bluebimma is offline   Reply With Quote
Old 06-30-2010, 10:31 PM   #21
familytruckster
Senior Member
 
Join Date: Jul 2009
Location: MD/PA/DC
Posts: 1,629
Vehicles
iTrader: (3)
Default

Do you remember the seller? There are some really really cheap kits, for like 116 bucks, then the FCP Groton ones that are 160-180, deutschepartsusa ~152
__________________
No more ti.
familytruckster is offline   Reply With Quote
Old 06-30-2010, 11:25 PM   #22
ti-billy
Senior Member
 
ti-billy's Avatar
 
Join Date: Mar 2010
Location: Tulsa, OK
Posts: 252
iTrader: (0)
Default

i bought the same kit and been rolling it like 3 months now, great quality parts and installed with no modifications, my car drives and sounds like new now
__________________
1996 318ti base: m44, 5 spd, lsd - 18x8 bremmer kraft wheels w/sumitumo tires 225/40R18 & bmw locking lug studs, 10mm spacers in rear, halo headlights, cold air intake, koni str.t struts and shocks w/mounts, h&r sport springs, serp belts, control arm & tie rod kits, front sway bar links, JVC kd-x50bt headunit w/ipod hook up in the glove box, alpine sps-500(front and rear), jl audio 10" powerwedge max, jl audio 250.1 amp, motor mounts, fuel filter, passenger side window motor, drivers lower window run, muffler hanger kit, various interior bulbs, left door striker/ajar switch, lower hood latches, changed from gray vinal to black leather shift and parking brake boots, m3 weighted shift knob, ngk-r spark plugs, magnecor spark plug wires(blue),new cabin micro-filters,new headliner & a-pillar mouldings, 5w20 synth-blend oil and filter, BG Ultra Guard syn. rear end fluid & ls additive, BG Syncro Shift II syn. manual trans fluids, stainless steel braided brake lines and dot 4 fluid, extra brake light mod, new p/s reservoir and rubber hoses

need to do - fix door panels, paint job, MORE MONEY!!
ti-billy is offline   Reply With Quote
Old 06-08-2011, 04:13 AM   #23
DataTraveler
Senior Member
 
DataTraveler's Avatar
 
Join Date: Mar 2009
Location: Detroit
Posts: 164
iTrader: (0)
Default

Quote:
Originally Posted by familytruckster View Post
Do you remember the seller? There are some really really cheap kits, for like 116 bucks, then the FCP Groton ones that are 160-180, deutschepartsusa ~152
Bumping this question. Any of you guys that bought this kit recall or can find the seller? Desire inexpensive, not cheap
DataTraveler is offline   Reply With Quote
Old 06-14-2011, 01:38 AM   #24
trikzta
Senior Member
 
trikzta's Avatar
 
Join Date: Jun 2009
Location: Miami, FL
Posts: 874
Vehicles
iTrader: (2)
Default

http://shop.ebay.com/foreigncarparts....c0.m270.l1313
__________________

Mods: 325is zender spoiler, 3" carbon fiber antenna, 5% tints rear windows, black out grills, Fogged air intake, Ds1 wheels, Rokkor coilovers, bilstein rear shocks, blacked out tails and home made angel eyes
trikzta is offline   Reply With Quote
Old 06-14-2011, 03:27 AM   #25
DataTraveler
Senior Member
 
DataTraveler's Avatar
 
Join Date: Mar 2009
Location: Detroit
Posts: 164
iTrader: (0)
Default

Thanks.

I realize now that I had the ebay names in the quote I quoted in my previous post... I feel thick now...
DataTraveler is offline   Reply With Quote
Old 06-14-2011, 03:29 AM   #26
familytruckster
Senior Member
 
Join Date: Jul 2009
Location: MD/PA/DC
Posts: 1,629
Vehicles
iTrader: (3)
Default

You can get the stuff there or at their actual site fcpgroton.com
__________________
No more ti.
familytruckster is offline   Reply With Quote
Old 06-14-2011, 03:52 AM   #27
DataTraveler
Senior Member
 
DataTraveler's Avatar
 
Join Date: Mar 2009
Location: Detroit
Posts: 164
iTrader: (0)
Default

thanks for the tip. adding that one to my list of bimmer parts sites
DataTraveler is offline   Reply With Quote
Old 06-24-2011, 01:39 AM   #28
Platanos
Senior Member
 
Platanos's Avatar
 
Join Date: May 2005
Location: PA
Posts: 1,906
iTrader: (5)
Default

Is this the "good deal" everyones talkin' bout?


http://www.fcpgroton.com/product-exe...ategory_id/540


I'm about to order this along with treehouse racing eyeballs and some powerflex 25mm sway bar bushings. Think it'll be a good setup??
__________________
Platanos is offline   Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Suspension Upgrade FAQ - READ THIS BEFORE POSTING! DustenT Suspension 77 12-09-2020 09:23 PM
squeaky front suspension ?? slinky2000 Suspension 8 03-23-2009 08:42 PM
e36 M3 front suspension ChosenGSR Suspension 9 06-11-2008 10:23 PM
Ti front end suspension socal318ti US and North America 1 12-02-2006 04:38 AM
Front suspension with 6-cyl iananderson02 Engine Swaps 6 01-21-2005 01:05 AM


All times are GMT +1. The time now is 06:48 PM.


.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org
© vBadvanced CMPS v3.2.2
[page compression: 112.70 k/134.28 k (16.07%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.