Hatch Removal (and dash too)

[pnosker]

Hey guys,

I'm in the middle of parting out my ti and I'm wondering how to pull the hatch off. I remember helping Arren part out his ti and we had to saw off his hatch... is there an easier way? I know you can take out the torx (I think) bolts at the top, but we had trouble getting the hatch hinges out.

Also, any tips on removing the dashboard?

Thanks,
Pat

[Maverix]

Well first you have to disconnect the flux capacitor. Then you have to use the aeonated integrity to make sure that the radiation does not leak from the plutonium.

Here is a picture on how the flux capacitor looks: http://www.thegreenhead.com/imgs/bac...-replica-3.jpg

Hope I helped!

[HoJo]

I'm sure you've figured something out by now, but I figured I would post just in case anybody else has the same question.

To remove the hatch, without cutting the hinges, remove the plastic interior trim at the top of the hatch. There are two cutouts on the glass side that let you get to the back side of the hinge. There are two 10mm nuts on each hinge that will separate the hatch from the hinge.